LEMON Manuals: Even more car manuals for everyone

DTC P0463

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0463 - LF, L3)

DTC P0463 Fuel gauge sender unit circuit high input
DETECTION CONDITION 
  • The PCM monitors the fuel level signal and fuel gauge sender unit output voltage from the instrument cluster. If the PCM detects a fuel level or fuel gauge sender unit output voltage that is too high, the PCM determines that the fuel gauge sender unit circuit has a malfunction.
  • Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Fuel gauge sender unit malfunction
  • Instrument cluster malfunction
  • PCM malfunction
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT INSTRUMENT CLUSTER  Yes Repair or replace the malfunctioning part, then go to Step 5.
No Go to the next step.
4 INSPECT FUEL GAUGE SENDER UNIT  Yes Replace the fuel tank, then go to the next step.
(See FUEL TANK REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY TROUBLESHOOTING OF DTC P0463 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Drive the vehicle under the FREEZE FRAME DATA condition.
  • Is the PENDING CODE for this DTC present?
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.