LEMON Manuals: Even more car manuals for everyone

DTC P0401

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0401 - LF, L3)

DTC P0401 EGR flow insufficient detected
DETECTION CONDITION 
  • The PCM monitors difference in intake manifold pressures when EGR is operated and when it is stopped. If the difference is too small, PCM determines that EGR flow insufficient.
  • Diagnostic support note 

  • This is an intermittent monitor (EGR system).
  • The MIL illuminates if PCM detects above malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for the same malfunction has been stored in PCM.
  • PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • EGR valve malfunction
  • MAP sensor malfunction
  • EGR gasket malfunction
  • PCM malfunction
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED 
  • Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (EGR system related) been recorded?
Yes Go to the next step.
No Record FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT FOR OTHER DTCS 
  • Turn the ignition switch off then to the ON position (Engine off).
  • Have other DTCs been stored?
Yes Repair circuit malfunction for applicable DTCs.
No Go to the next step.
4 INSPECT VACUUM HOSE CONDITION 
  • Inspect vacuum hoses for clogs, any damages, frozen, or vacuum leakage.
  • Is there any malfunction?
Yes Replace vacuum hoses, then go to Step 8.
No Go to the next step.
5 INSPECT EGR VALVE MALFUNCTION  Yes Go to the next step.
No Replace the EGR valve, then go to Step 8.
6 INSPECT MAP SENSOR MALFUNCTION  Yes Go to the next step.
No Replace MAP sensor, then go to Step 8.
7 INSPECT EGR VALVE PASSAGE 
  • Turn the ignition switch off.
  • Remove the EGR valve.
  • Is gasket installation normal?
Yes Go to the next step.
No Install gasket correctly, then go to the next step.
8 MONITOR EGR SYSTEM BY DRIVE MODE 
  • Clear DTC from PCM memory using WDS or equivalent.
  • Run PCM Adaptive Memory Procedure Drive Mode.

    (See PCM ADAPTIVE MEMORY PRODUCTION DRIVE MODE ).

  • Stop vehicle and access ON BOARD READINESS TEST to inspect DRIVE MODE completion status.
  • Verify FUEL_EVAL and EGR_EVAL PIDs status.
  • Does FUEL_EVAL and EGR_EVAL PIDs change to Yes?
Yes Go to the next step.
No Retry this step.
9 VERIFY TROUBLESHOOTING OF DTC P0401 COMPLETED  Yes Go to the next step.
No Replace the PCM, then go to the next step.
10 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.