LEMON Manuals: Even more car manuals for everyone

DTC P0328

DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0328 - LF, L3)

DTC P0328 KS circuit high input
DETECTION CONDITION 
  • The PCM monitors the input signal from the KS when the engine is running. If the input voltage between PCM terminals for the KS circuit is above 4.77 V (1) , above 4.9 V (2)  the PCM determines that KS circuit has a malfunction.
  • Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction conditions during first drive cycle.
  • PENDING CODE is available if the PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • KS malfunction
  • Connector or terminal malfunction
  • Short to power supply in wiring harness between KS terminal A and PCM terminal 2U(3), 2Q(4)
  • Short to power supply in wiring harness between KS terminal B and PCM terminal 2V(3), 2R(4)
  • PCM malfunction
G04313402Courtesy of MAZDA MOTORS CORP.
(1) California emission regulation applicable model
(2) Except for California emission regulation applicable model
(3) LF MTX, L3 and California emission regulation applicable model with LF ATX
(4) Except for California emission regulation applicable model with LF ATX
DIAGNOSTIC PROCEDURE CHART

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT KS CONNECTOR TERMINAL 
  • Turn the ignition switch off.
  • Disconnect KS connector.
  • Inspect for poor connection at terminals A and B (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
Yes Repair the terminal, then go to Step 7.
No Go to the next step.
4 INSPECT KS  Yes Go to the next step.
No Replace the KS, then go to Step 7.
5 INSPECT KNOCK SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY 
  • Turn the ignition switch to the ON position (Engine off).
  • Measure the voltage between KS terminal A (wiring harness-side) and body ground and KS terminal B (wiring harness-side) and body ground?
  • Is any voltage reading?
Yes Repair or replace wiring harness for short to power supply, then go to Step 7.
No Go to the next step.
6 INSPECT PCM CONNECTOR 
  • Disconnect PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
Yes Repair or replace the terminal, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P0328 COMPLETED 
  • Make sure to connect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine.
  • Is the same DTC present?
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC troubleshooting.
(See DTC TABLE ).
No Troubleshooting completed.