DTC P0102
DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0102 - LF, L3)
| DTC P0102 | MAF sensor circuit low input | ||||
|---|---|---|---|---|---|
| DETECTION CONDITION |
Diagnostic support note |
||||
| POSSIBLE CAUSE |
|
||||
|
|||||
DIAGNOSTIC PROCEDURE CHART
| STEP | INSPECTION | ACTION | |||||
|---|---|---|---|---|---|---|---|
| 1 | VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
|
Yes | Go to the next step. | ||||
| No | Record the FREEZE FRAME DATA on the repair order, then go to the next step. | ||||||
| 2 | VERIFY RELATED REPAIR INFORMATION AVAILABILITY
|
Yes | Perform repair or diagnosis according to the available repair information.
|
||||
| No | Go to the next step. | ||||||
| 3 | INSPECT POOR CONNECTION OF MAF SENSOR CONNECTOR
|
Yes | Repair or replace the terminals, then go to Step 8. | ||||
| No | Go to the next step. | ||||||
| 4 | INSPECT POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT
|
Yes | Go to the next step. | ||||
| No | Inspect for open circuit in wiring harness between MAF/IAT sensor terminal B (wiring harness-side) and main relay. Repair or replace wiring harness, then go to Step 8. | ||||||
| 5 | INSPECT POOR CONNECTION OF PCM CONNECTOR
|
Yes | Repair the terminal, then go to Step 8. | ||||
| No | Go to the next step. | ||||||
| 6 | INSPECT MAF SENSOR SIGNAL CIRCUIT FOR OPEN CIRCUIT | Yes | Go to the next step. | ||||
| No | Repair or replace the wiring harness, then go to Step 8. | ||||||
| 7 | INSPECT MAF SENSOR SIGNAL CIRCUIT FOR SHORTS
|
Yes | Repair or the wiring harness, then go to the next step. | ||||
| No | Replace the MAF/IAT sensor, then go to the next step. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION ). |
||||||
| 8 | VERIFY TROUBLESHOOTING OF DTC P0102 COMPLETED
|
Yes | Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION ). |
||||
| No | Go to the next step. | ||||||
| 9 | VERIFY AFTER REPAIR PROCEDURE
|
Yes | Go to the applicable DTC troubleshooting. (See DTC TABLE ). |
||||
| No | Troubleshooting completed. | ||||||
|
|||||||