DTC P0101
DETECTION CONDITION AND POSSIBLE CAUSE (DTC P0101 - LF, L3)
| DTC P0101 | MAF circuit range/performance problem |
|---|---|
| DETECTION CONDITION |
Diagnostic support note |
| POSSIBLE CAUSE |
|
DIAGNOSTIC PROCEDURE CHART
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
|
Yes | Go to next step. |
| No | Record FREEZE FRAME DATA on repair order, then go to next step. | ||
| 2 | VERIFY RELATED REPAIR INFORMATION AVAILABILITY
|
Yes | Perform repair or diagnosis according to available repair information.
|
| No | Go to next step. | ||
| 3 | VERIFY CURRENT INPUT SIGNAL STATUS IS CONCERN INTERMITTENT OR CONSTANT
|
Yes | Go to next step. |
| No | Intermittent concern exists. Go to INTERMITTENT CONCERNS TROUBLESHOOTING procedure. (See INTERMITTENT CONCERN TROUBLESHOOTING ). |
||
| 4 | CHECK MAF SENSOR TERMINALS FOR ELECTRICAL CORROSION
|
Yes | Repair or replace suspected terminal or MAF sensor, then go to Step 6. |
| No | Go to next step. | ||
| 5 | INSPECT PCM CONNECTOR FOR POOR CONNECTION
|
Yes | Repair terminal, then go to next step. |
| No | Go to next step. | ||
| 6 | VERIFY TROUBLESHOOTING OF DTC P0101 COMPLETED
|
Yes | Replace PCM, then go to next step. |
| No | Go to next step. | ||
| 7 | VERIFY AFTER REPAIR PROCEDURE
|
Yes | Go to applicable DTC inspection. (See DTC TABLE ). |
| No | Troubleshooting completed. | ||