LEMON Manuals: Even more car manuals for everyone

Not using SST (WDS or equivalent)

  1. Disconnect the negative battery cable.
  2. Remove the fuel pump relay.
    CAUTION:
    • Be careful to short the specified terminal as shorting the wrong terminal of the main fuse block may cause a malfunction.
      Fig 1: Removing Fuel Pump Relay
      G04313612Courtesy of MAZDA MOTORS CORP.
  3. Using a jumper wire, short fuel pump relay terminals C and D and connect the negative battery cable to start the fuel pump.
  4. Fig 2: Connecting Jump Wire To Fuel Pump Relay Terminals
    G04313613Courtesy of MAZDA MOTORS CORP.
  5. Verify that there is no fuel leakage from the pressurized parts.
    • If there is leakage, replace the fuel hoses and clips.
    • If there is damage on the seal on the fuel pipe side, replace the fuel pipe.

      Standard 

      There shall be no leakage after 5 min. 

  6. After reinstallation, repeat step  3-- 4 in the fuel leakage inspection.