LEMON Manuals: Even more car manuals for everyone

Removal and Installation

WARNING:
  • All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height adjusters (if so equipped), child safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
    Fig 1: Removing Child Safety Seat Tether Anchor Cover
    G03374431Courtesy of MAZDA MOTORS CORP.
  1. At the roof, near the rear liftgate door, remove the child safety seat tether anchor cover.
  2. Fig 2: Removing Child Safety Seat Tether Anchor
    G03374432Courtesy of MAZDA MOTORS CORP.
  3. Remove the bolt and the child safety seat tether anchor.
  4. WARNING:
    • It is important that the bolt/anchor be securely tightened to specification. Otherwise, the child's safety seat may not be properly secured, and the child can be injured in case of a sudden stop or accident.
    NOTE:
    • Rework the sheet metal to its original condition and structural integrity.
    NOTE:
    • Make sure to tighten the bolts to specification.
  5. To install, reverse the removal procedure.
  6. Check the active restraint system for correct operation.