Removal Note:
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING:
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
NOTE:
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
- The SRS must be fully operational and free faults before releasing the vehicle to the customer.
- Depower the SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Remove the effected seat. See SEAT BUCKET FRONT REMOVAL/INSTALLATION .
- Remove the 60 percent bench armrest. See SEAT ARMREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION .
- Remove the 60 percent bench seat backrest assembly. See SEAT BACKREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION .
- Remove the seat track spring.
- Remove the push nuts.
- Remove the seat track adjustment lever.
- Remove one side of the seat track adjustment lever at a time.
- Remove the two rear seat cushion-to-frame bolts.
- Remove the two front seat cushion-to-frame bolts and remove the seat track from the seat cushion frame.
- Remove the eight nuts and separate the seat track from the seat cushion frame.