Installation Note:
All seats
- Install the backrest assembly.
- Install the two outboard backrest bolts.
- Install the two inboard backrest bolts.
- Install the inboard recliner cable.
- Position the recliner cable.
- Install the recliner cable end and swivel the cable.
- Attach the recliner cable to its anchor point.
- Install the outboard recliner cable.
- Position the recliner cable.
- Install the recliner cable end and swivel the cable.
- Attach the recliner cable to its anchor point.
- Position material and install the outboard pin-type retainer.
- Install the safety belt buckle pretensioner and install the safety belt buckle pretensioner nut.
- Route the safety belt buckle pretensioner wire harness through the seat frame and attach the safety belt buckle pretensioner wire harness to the seat cushion pan.
- Install the safety belt buckle pretensioner cover and install the screw.
- Attach the inboard side J-clip.
- Attach the inboard side rear J-clip.
- Position the side shield and install the two clips (one shown).
- Install the front side shield screw.
- Install the screw on the side shield.
Seats with manual lumbar support
- Route the lumbar adjustment cable as noted during removal.
- Connect the lumbar support adjuster and the lumbar adjustment cable.
- Install the lumbar support adjuster and the two screws.
- Install the lumbar knob.
All vehicles
- Install the recliner handle and install the screw.
- Install the affected seat.
- Repower the SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM .