LEMON Manuals: Even more car manuals for everyone

Removal Note:

WARNING:
  • The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING:
  • To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
  • If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered. 
NOTE:
  • The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
  • The SRS must be fully operational and free faults before releasing the vehicle to the customer.
  1. Depower the SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the affected seat. See SEAT BUCKET FRONT REMOVAL/INSTALLATION  .
  3. Remove the 60 percent bench armrest. See SEAT ARMREST FRONT - 60 PERCENT BENCH REMOVAL/INSTALLATION 
    Fig 1: Removing Recliner Handle
    G01937256Courtesy of MAZDA MOTORS CORP.
  4. Remove the recliner handle screw and the recliner handle.
    Fig 2: Locating Screw On Side Shield
    G01937257Courtesy of MAZDA MOTORS CORP.
  5. Remove the screw on the side shield.
    Fig 3: Removing Screw On Side Shield
    G01937258Courtesy of MAZDA MOTORS CORP.
  6. Remove the screw on the side shield.
    Fig 4: Removing Screw On Side Shield
    G01937259Courtesy of MAZDA MOTORS CORP.
  7. Remove the screw on the side shield.
    Fig 5: Removing Outboard Recliner Cable Anchor
    G01937260Courtesy of MAZDA MOTORS CORP.
  8. Remove the outboard recliner cable anchor and swivel the recliner cable end and remove.
    Fig 6: Removing Outboard Pin-Type Retainer
    G01937261Courtesy of MAZDA MOTORS CORP.
  9. Remove the outboard pin-type retainer and position material aside.
    Fig 7: Removing Two Outboard Backrest Recliner Bolts
    G01937262Courtesy of MAZDA MOTORS CORP.
  10. Remove the two outboard backrest recliner bolts.
    Fig 8: Removing Inboard Recliner Cable Anchor
    G01937263Courtesy of MAZDA MOTORS CORP.
  11. Remove the inboard recliner cable anchor and swivel the recliner cable end and remove.
    Fig 9: Removing Front Inboard Backrest Recliner Bolt
    G01937264Courtesy of MAZDA MOTORS CORP.
  12. Remove the front inboard backrest recliner bolt.
    Fig 10: Removing Inboard Rear Bolt Cover
    G01937265Courtesy of MAZDA MOTORS CORP.
  13. Remove the inboard rear bolt cover.
    Fig 11: Removing Inboard Rear Backrest Recliner Bolt
    G01937266Courtesy of MAZDA MOTORS CORP.
  14. Remove the inboard rear backrest recliner bolt.
  15. Remove the backrest assembly.