Motor Relay
NOTE:
Motor relay is part of ABS relay. If motor relay is defective, replace ABS relay.
- ABS relay is located in rear left side of engine compartment near brake master cylinder. Turn ignition switch to OFF position. Remove ABS relay. Measure resistance between ABS relay terminals "e" and "h", or between ABS relay terminals "a" and "h". See Figure. Resistance should be 50-90 ohms. If resistance is not as specified, replace ABS relay. If resistance is as specified, go to next step.
- Check for continuity between ABS relay terminals "b" and "f". If continuity does not exist, go to next step. If continuity exists, replace ABS relay.
- Apply 12 volts to ABS relay terminal "g". Connect jumper wire between chassis ground and ABS relay terminal "h". See Figure. Check for continuity between ABS relay terminals "b" and "f". Continuity should exist. If continuity does not exist, replace ABS relay.