Possible Causes
- Wiring, terminals or connectors
- Network communication concern
- Door ajar switch
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.
Harness Side
| Circuit | Pin |
- CJ1: RECHECK THE ABS MODULE DTCS
- Ignition ON, engine OFF.
Carry out the ABS self-test.
- Retrieve and record all ABS module DTCs.
- Is DTC P166B:62 currently present and active in the ABS module?
Yes No Go to CJ2. The condition causing the concern is not present at this time. RETURN to the ABS module DTC chart and DIAGNOSE all other ABS module DTCs.
- Ignition ON, engine OFF.
- CJ2: CHECK FOR DTCS IN THE BCM
Carry out the BdyCM self-test.
- Retrieve and record all BCM DTCs.
- Are there any DTCs currently present and active in the BCM?
Yes No DIAGNOSE all BCM DTCs before diagnosing ABS module DTC P166B:62. REFER to Multifunction Electronic Module article. Go to CJ3.
- CJ3: CHECK THE DOOR LOCK STATUS CIRCUIT FOR AN OPEN
- Ignition OFF.
- ABS Module connector disconnected. (C135)
- Front Door Latch LH connector disconnected.
- Measure the resistance between:
(+) ABS Module (C135) Connector, Harness Side (-) Front Door Latch LH Connector, Harness Side D DOOR D DOOR - Is the resistance less than 3 ohms?
Yes No Go to CJ4. REPAIR the circuit.
- CJ4: CHECK THE DOOR LOCK STATUS CIRCUIT FOR A SHORT TO GROUND