LEMON Manuals: Even more car manuals for everyone

Electronic Pressure Control (EPC) Solenoid: Removal

  1. Remove the manual control lever. For additional information, see MANUAL CONTROL LEVER SHAFT AND SEAL .
  2. CAUTION: Do not pull on the molded lead frame. This may cause damage to the connector ends. Carefully pry up on the locking tabs to disconnect the solenoids. Disconnect the molded lead frame from the solenoids.
    Fig 1: Disconnecting Molded Lead Frame
    G01335926Courtesy of FORD MOTOR CO.
  3. Disconnect the molded lead frame from the solenoids.
    1. Disconnect the shift solenoid SSA and SSB.
    2. Disconnect the torque converter clutch (TCC).
    3. Disconnect the electronic pressure control (EPC) solenoid.
    4. Disconnect the bulkhead inter-connector.
  4. Remove the EPC solenoid.
    1. Remove the bolt and EPC solenoid bracket.
    2. Remove the EPC solenoid.
    Fig 2: Removing EPC Solenoid
    G01335927Courtesy of FORD MOTOR CO.