Test C: Memory Mirror Inoperative From Remote Transmitter
- Place transmission in Park. Turn ignition switch to LOCK position. Connect New Generation Star (NGS) tester to data link connector. Retrieve and record DTCs. Clear DTCs. Perform Driver Seat Module (DSM) self-test. If no DSM DTCs were retrieved during self-test, go to next step. If any DSM DTCs were retrieved during self-test, perform appropriate test. See DSM DTC DEFINITIONS table under SYSTEM TESTS.
- Turn ignition switch to LOCK position. Disconnect Remote Anti-Theft Personality (RAP) module harness connector C257. See Fig 1
and Fig 2
. Disconnect memory set switch harness connector. Measure resistance in Brown/Light Green wire between terminal No. 6 at RAP module harness connector C257 and terminal No. 3 at memory set switch harness connector. See Figure
. Also, measure resistance in Black/Orange wire between terminal No. 18 at RAP module harness connector C257 and terminal No. 4 at memory set switch harness connector. If either resistance reading is greater than 5 ohms, repair open in appropriate wire. If both resistance readings are 5 ohms or less, diagnosis remote keyless entry system concern. See REMOTE KEYLESS ENTRY SYSTEM article.
Courtesy of FORD MOTOR CO.
Courtesy of FORD MOTOR CO.