LEMON Manuals: Even more car manuals for everyone

Inspection [10/2014 - ]: Procedure

  1. INSPECT POWER SWITCH 
    1. GTY376437Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Power Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      5 (SS1) - 6 (AGND)
      1 (SS2) - 6 (AGND)
      Not pushed 10 kΩ or higher
      5 (SS1) - 6 (AGND)
      1 (SS2) - 6 (AGND)
      Pushed Below 1 Ω

      If the result is not as specified, replace the power switch.

    2. Apply battery voltage between the terminals of the power switch, and check the illumination condition of the power switch.

      OK

      Measurement Condition Specified Condition
      Battery positive (+) → Terminal 9 (SWIL)
      Battery negative (-) → Terminal 6 (AGND)
      Illuminates
      NOTE:
      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator will not illuminate.
      • If the voltage is too low, the indicator will not illuminate.

      If the result is not as specified, replace the power switch.