LEMON Manuals: Even more car manuals for everyone

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 11

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

  4. REMOVE PARKING ASSIST ECU 

    Refer to REMOVAL [05/2023 - ]

  5. REMOVE INTEGRATION CONTROL SUPPLY WITH BRACKET 
    NOTE:
    • Do not use a integration control supply that has been dropped.
    • When disconnecting a wire harness of any component connected to the supply power of the integrated capacitor (integration control supply) or when removing the integrated capacitor (integration control supply), make sure to wait 5 minutes or more after turning the ignition switch off for self-diagnosis to complete and the voltage of the integrated capacitor (integration control supply) to discharge.
    1. Disconnect the connector.
    2. Remove the 2 bolts and 2 nuts.
    3. Detach the guide and remove the integration control supply with bracket as shown in the illustration.
      GTY1242918Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction Connector
      Bolt Nut
  6. REMOVE NO. 1 INTEGRATION CONTROL SUPPLY BRACKET 
    1. Remove the 2 bolts.
      GTY1242457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the guide and remove the No. 1 integration control supply bracket.
  7. REMOVE NO. 2 INTEGRATION CONTROL SUPPLY BRACKET 
    1. Remove the 2 bolts.
      GTY1242458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the guide and remove the No. 2 integration control supply bracket.
  8. REMOVE INTEGRATION CONTROL SUPPLY