LEMON Manuals: Even more car manuals for everyone

Adjustment [10/2014 - 05/2019]: Procedure

  1. INSPECT TIRES 

    Refer to INSPECTION [10/2014 - 09/2015] , or refer to INSPECTION [09/2015 - ]

  2. MEASURE VEHICLE HEIGHT 

    See step  2

  3. INSPECT CAMBER 
    GTY368869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Gauge
    1. Install a camber-caster-kingpin gauge or set the vehicle on a wheel alignment tester.
    2. Inspect the camber.

      Standard Camber Inclination (Unloaded Vehicle)

      Tire Size Camber Inclination Right-left Difference
      225/65R17 -1°15' +/-45' (-1.25° +/-0.75°) 45' (0.75°) or less
      225/60R18 -1°20' +/-45' (-1.33° +/-0.75°) 45' (0.75°) or less
      1. If the measured value is not within the specified range, inspect the suspension parts for damage and wear. Replace parts as necessary as the camber cannot be properly adjusted with any damaged or worn parts.
  4. INSPECT TOE-IN 
    1. Bounce the vehicle up and down at the corners to stabilize the suspension and inspect toe-in.
      GTY380470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Front of the Vehicle

      Toe-in (Unloaded Vehicle)

      A + B
      C - D
      A + B: 0°10' +/-10' (0.16° +/-0.16°)
      C - D: 2.0 +/-2.0 mm (0.08 +/-0.08 in.)

      HINT: 

      If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.

  5. ADJUST TOE-IN 
    GTY507243Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Loosen the toe adjust cam nut.
    2. Turn the adjust cams by an equal amount to adjust the toe-in.
      GTY507244Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Toe-in (Unloaded Vehicle)

      - A + B
      C - D
      Toe-in
      (Total)
      A + B: 0°10' +/-10' (0.16° +/-0.16°)
      C - D: 2.0 +/-2.0 mm (0.08 +/-0.08 in.)

      HINT: 

      • Try to adjust the toe-in to the center value.
      • The toe-in will change by approximately 3.6 mm (0.142 in.) for each gradation of the cam.
      • Perform adjustments so that the value is as close as possible to the median of the specified range.
    3. Tighten the toe adjust cam nut.
      GTY507243Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

  6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  7. PERFORM YAW RATE AND ACCELERATION SENSOR CALIBRATION 

    Refer to CALIBRATION [10/2014 - 05/2019]

  8. ADJUST LANE DEPARTURE WARNING CAMERA (w/ LANE DEPARTURE WARNING CAMERA) 

    Refer to ADJUSTMENT [10/2014 - 09/2017] , or refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [09/2017 - 05/2019]

  9. PERFORM INITIALIZATION 

    Refer to INITIALIZATION [10/2014 - 09/2017] , or refer to INITIALIZATION [09/2017 - 05/2019]