Installation [10/2014 - 05/2019]: Procedure
- INSTALL BRAKE ACTUATOR WITH BRACKET
- Install the brake actuator with bracket with the 3 nuts.
Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
NOTE:- Tighten the 3 nuts uniformly in alphabetical order.
- Be careful not to damage the brake tubes.
- Connect the 3 clamps to the brake actuator bracket assembly.
- Temporarily install each brake line to the correct positions of the brake actuator assembly with bracket as shown in the illustration.
HINT:
- *1: to front wheel cylinder RH
- *2: to front wheel cylinder LH
- *3: to rear wheel cylinder RH
- *4: to rear wheel cylinder LH
- *5: from front master cylinder
- *6: from rear master cylinder
- Using a union nut wrench, tighten each 6 brake lines.
*a Torque Wrench Fulcrum Length Specified tightening torque
Torque: 15.2 N*m (155 kgf*cm, 11 ft.*lbf)
HINT:
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [10/2014 - 09/2017] , or refer to PRECAUTION [09/2017 - 05/2019]
- When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
- Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
- Connect the clamp to the brake actuator bracket assembly.
- Connect the wire harness connector to the brake actuator assembly, and then push up the lock lever to apply the lock.NOTE:
- Before connecting the wire harness connector, make sure that the surfaces of the wire harness connector are free of foreign matter.
- After connecting the wire harness connector, make sure that the lock lever is securely locked.
- Install the brake actuator with bracket with the 3 nuts.
- INSTALL AIR CLEANER CASE SUB-ASSEMBLY
Refer to INSTALLATION [10/2014 - 05/2019]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2014 - 09/2017] , or refer to INITIALIZATION [09/2017 - 05/2019]
- BLEED BRAKE SYSTEM
- PERFORM SYSTEM VARIANT LEARNING AND ACCELERATION SENSOR ZERO POINT CALIBRATION
Refer to CALIBRATION [10/2014 - 05/2019]
- INSPECT BRAKE ACTUATOR USING GTS