Installation [09/2015 - ]: Procedure
- INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
- Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator assembly.NOTE:
- Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
- When inserting the injector, be careful not to damage the O-ring.
- While turning the pressure regulator left and right, install it to the delivery pipe.
- Install the 2 bolts.
Torque: 10 N*m (107 kgf*cm, 7 ft.*lbf)
- Connect the vacuum sensing hose to the pressure regulator assembly.
- Connect the No. 2 fuel tube to the pressure regulator assembly (Refer to PRECAUTION [09/2015 - ]
).
- Apply a light coat of gasoline or spindle oil to a new O-ring, and install it to the pressure regulator assembly.
- INSTALL AIR CLEANER HOSE ASSEMBLY
Refer to PROCEDURE - Step 10
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - ] ).
- INSPECT FOR FUEL LEAK
See step 11
- INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 69
- INSTALL UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 14