Replacement [09/2015 - ]: Procedure
- DRAIN TRANSFER OIL
- ADD TRANSFER OIL
- Install a new gasket into the drain plug and then install the drain plug with a 10 mm hexagon wrench.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
- Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
Oil grade
Toyota Genuine Transfer gear oil LL 80 or equivalent
Standard capacity
0.7 liters (0.7 US qts, 0.6 Imp. qts)
TEXT IN ILLUSTRATION*a 0 to 5 mm (0 to 0.196 in.) NOTE:- Add oil slowly.
- Add oil a little at a time, waiting several minutes between each addition of oil.
- Keep the vehicle level during inspection.
- Install a new gasket into the filler plug and then install the plug with a 10 mm hexagon wrench.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
- Drive the vehicle and check the oil level again.
- Install a new gasket into the drain plug and then install the drain plug with a 10 mm hexagon wrench.