Removal [09/2014 - 10/2015]: Procedure
- REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE
(See page See step 7).
- REMOVE FUEL TANK VENT TUBE ASSEMBLY
(See page See step 4)
- DRAIN FUEL
- REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
- for 2WD (Refer to PROCEDURE - Step 4 )
- for AWD (Refer to PROCEDURE - Step 4 )
- DISCONNECT FUEL TUBE
Detach the 2 claws of the fuel tube connector retainer, push down the retainer and disconnect the fuel tank main tube sub-assembly for the LH side as shown in the illustration.
TEXT IN ILLUSTRATION*1 Retainer *2 Fuel Tube Connector *3 Nylon Tube *4 O-Ring *5 Pipe NOTE:- Remove any dirt and foreign objects on the fuel tube connector before performing this work.
- Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has O-rings that seal the pipe.
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the nylon tube.
- Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel pump tube.
- If the fuel tube connector and pipe are stuck, push and pull on them to release them.
Detach the 2 claws of the fuel tube connector retainer, push down the retainer and disconnect the fuel tank main tube sub-assembly for the RH side and fuel tank return tube as shown in the illustration.
TEXT IN ILLUSTRATION*1 Retainer *2 Fuel Tube Connector *3 Nylon Tube *4 O-Ring *5 Pipe NOTE:- Remove any dirt and foreign objects on the fuel tube connector before performing this work.
- Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has O-rings that seal the pipe.
- Perform this work by hand. Do not use any tools.
- Do not forcibly bend, twist or turn the nylon tube.
- Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel pump tube.
- If the fuel tube connector and pipe are stuck, push and pull on them to release them.
- DISCONNECT FUEL TANK TO FILLER PIPE HOSE
- DISCONNECT FUEL CUT OFF VALVE TUBE
Disconnect the quick connector and clamp (Refer to PRECAUTION [09/2014 - 10/2015] ).
- DISCONNECT FUEL TANK BREATHER TUBE
Disconnect the quick connector and clamp (Refer to PRECAUTION [09/2014 - 10/2015] ).
- REMOVE REAR SUSPENSION MEMBER BRACE
(Refer to PROCEDURE - Step 41 )
- REMOVE FUEL TANK ASSEMBLY
- REMOVE FUEL TUBE
- REMOVE FUEL TANK CUSHION
- REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY