Reassembly [09/2014 - 10/2015]: Procedure
- INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
See step 1
- INSTALL FUEL MAIN VALVE ASSEMBLY
- Apply a light coat of gasoline to 2 new O-rings and install them to the fuel main valve assembly.
- Install the fuel main valve assembly to the fuel filter assembly.NOTE:
- If the fuel main valve assembly and fuel pressure regulator assembly are mistakenly interchanged when they are installed, the engine may stall. Always make sure the installation positions are correct.
- When installing the O-ring, make sure that it does not become pinched or cut.
- INSTALL FUEL WITH FILTER PUMP ASSEMBLY
HINT:
Perform "Inspection After Repairs" after replacing the fuel pump (Refer to INITIALIZATION [09/2014 - 10/2015] ).
Install the fuel pump spacer to the fuel pump.
TEXT IN ILLUSTRATION*1 Fuel Pump Spacer *2 O-Ring - Apply a light coat of gasoline to a new O-ring, and then install the O-ring to the fuel pump.
- Attach the 5 claws of the fuel filter to install the fuel pump.NOTE:
- When installing the O-ring, make sure that it does not become pinched or cut.
- Securely attach the claws.
- INSTALL NO. 1 FUEL SUCTION SUPPORT
- Install the No. 1 fuel suction support to the fuel with filter pump assembly.
- INSTALL FUEL PUMP HARNESS
- Install the fuel pump connector to the fuel with filter pump assembly.
- INSTALL JET PUMP
- Apply a light coat of gasoline to a new O-ring and install the O-ring to the jet pump.
Install the jet pump to the No. 1 fuel sub-tank as shown in the illustration.
NOTE:When installing the O-ring, make sure that it does not become pinched or cut.
- Install the jet pump to the No. 1 fuel sub-tank.NOTE:
Securely attach the claws.
- INSTALL FUEL FILTER ASSEMBLY
- Attach the 2 claws to install the fuel filter assembly to the No. 1 fuel sub-tank.
- INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
- Install the spring to the fuel suction plate shaft.
- Install the fuel suction plate sub-assembly to the No. 1 fuel sub-tank.
- Install a new E-ring.
- Connect the fuel pump harness connector to the fuel suction plate sub-assembly.NOTE:
Make sure that the claw of the fuel pump connector is attached securely.
Connect the fuel pump harness to the clamp as shown in the illustration.
NOTE:- Attach A first and then B when connecting the fuel pump harness to the clamp.
- Do not twist or excessively pull the fuel pump harness.
- INSTALL FUEL SENDER GAUGE ASSEMBLY
See step 4