Installation (08/2011 - ): Installation
- INSTALL FUEL INJECTOR ASSEMBLY
- Attach the 3 clamps to install the No. 6 wire harness to the delivery pipe RH.
- Attach the 3 clamps to install the No. 7 wire harness to the delivery pipe LH.
- Apply gasoline or spindle oil to a new O-ring and install it to the injector.
NOTE:
Make sure that there is no damage or foreign material in the groove of the injector when installing the O-ring.
- Connect the injector connector.
- Install the injector to the delivery pipe as shown in the illustration.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:- Make sure that there are no scratches or foreign matter in or around the insertion hole of the delivery pipe.
- When inserting the injector, be careful not to damage the O-ring.
- Attach the part of the injector labeled B between the parts of the delivery pipe labeled A.
- Check that each injector is installed to the delivery pipe facing the direction shown in the illustration.
- INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY LH
- Install the 2 delivery pipe spacers and 4 insulators to the cylinder head LH.
- Install the delivery pipe (with injectors) to the cylinder head LH.
- Install the 2 bolts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
- Connect the No. 7 wire harness connector.
- INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY RH
- Install the 2 delivery pipe spacers and 4 insulators to the cylinder head RH.
- Install the delivery pipe (with injectors) to the cylinder head RH.
- Install the 2 bolts.
Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
- Connect the No. 6 wire harness connector.
- Connect the ventilation hose.
- CONNECT NO. 1 FUEL HOSE
- Connect the No. 1 fuel hose to the fuel delivery pipe LH. Refer to PRECAUTION .
- CONNECT NO. 1 FUEL TUBE
- LH Side:
Connect the No. 1 fuel tube to the delivery pipe LH. Refer to PRECAUTION .
- RH Side:
Connect the No. 1 fuel tube to the delivery pipe RH (for metallic type). Refer to PRECAUTION .
- LH Side:
- CONNECT NO. 2 FUEL TUBE
- Connect the No. 2 fuel tube to the fuel pressure regulator. Refer to PRECAUTION .
- INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
- Install the No. 1 engine cover sub-assembly.
- INSTALL NO. 3 ENGINE COVER
- Install the No. 3 engine cover.
- INSTALL AIR CLEANER HOSE ASSEMBLY . Refer to INSTALLATION - Step 10
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- INSPECT FOR FUEL LEAK
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) and Techstream main switch on.NOTE:
Do not start the engine.
- Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
- Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.
- INSTALL V-BANK COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 72
- INSTALL UPPER RADIATOR SUPPORT SEAL . Refer to INSTALLATION - Step 2
- INSTALL ENGINE ROOM SIDE COVER LH . Refer to INSTALLATION - Step 3
- INSTALL ENGINE ROOM SIDE COVER RH . Refer to INSTALLATION - Step 4