LEMON Manuals: Even more car manuals for everyone

System Outline

With the ignition SW turned on, current flows to TERMINAL (A) 2 of the wiper and washer SW and TERMINAL 2 of the front wiper motor through the FR WIP fuse. Current also flows to TERMINAL 1 of the washer motor through the WASHER fuse.

  1. Low Speed Position 

    If the wiper and washer SW is turned to the LO position, current flows from TERMINAL (A) 2 of the wiper and washer SW then out TERMINAL (A) 3 to TERMINAL 1 of the front wiper motor and out TERMINAL 5 to GROUND and causes the front wiper motor to run at low speed.

  2. High Speed Position 

    If the wiper and washer SW is turned to the HI position, the current flows from TERMINAL (A) 2 of the wiper and washer SW then out TERMINAL (A) 4 to TERMINAL 4 of the front wiper motor and out TERMINAL 5 to GROUND and causes the front wiper motor to run at high speed.

  3. INT Position 

    If the wiper and washer SW is turned to the INT position, the wiper relay operates and current flows from TERMINAL (A) 2 of the wiper and washer SW and out TERMINAL (B) 2 to GROUND. This activates the intermittent circuit and current flows from TERMINAL (A) 2 of the wiper and washer SW then out TERMINAL (A) 3 to TERMINAL 1 of the front wiper motor and out TERMINAL 5 to GROUND and the wiper operates. The intermittent operation is controlled by a condenser charge and discharge function in the relay.

  4. Washer Continuous Operation 

    If the wiper and washer SW is pulled to the WASHER position (Washer SW ON position), current flows from the WASHER fuse to TERMINAL 1 of the washer motor then out TERMINAL 2 to TERMINAL (B) 3 of the wiper and washer SW and out TERMINAL (B) 2 to GROUND and causes the washer motor to run and the window washer to spray. Simultaneously, current flows from the WIP fuse to TERMINAL (A) 2 of the wiper and washer SW then out TERMINAL (A) 3 to TERMINAL 1 of the front wiper motor and out TERMINAL 5 to GROUND, causing the wipers to function.