LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. INSPECT OUTER MIRROR CONTROL ECU (POWER SOURCE) 
    1. Disconnect the L10 (M10) connector.

      (): RH side

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Outer mirror control ECU RH: 

      Voltage 

    VOLTAGE SPECIFICATION

    Tester Connection Condition Specified Condition
    L10-6 (BDR) - Body ground Always 10 to 14 V
    L10-4 (CPUB) - Body ground Always 10 to 14 V
    L10-3 (SIG) - Body ground Engine switch on (IG) 10 to 14 V
    Fig 1: Identifying L10 (M10) Connector Terminals
    G05828393Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Resistance 

    RESISTANCE SPECIFICATION

    Tester Connection Condition Specified Condition
    L10-1 (GND) - Body ground Always Below 1 Ω

    Outer mirror control ECU LH: 

    Voltage 

    VOLTAGE SPECIFICATION

    Tester Connection Condition Specified Condition
    M10-6 (BDR) - Body ground Always 10 to 14 V
    M10-4 (CPUB) - Body ground Always 10 to 14 V
    M10-3 (SIG) - Body ground Engine switch on (IG) 10 to 14 V

    Resistance 

    RESISTANCE SPECIFICATION

    Tester Connection Condition Specified Condition
    M10-1 (GND) - Body ground Always Below 1 Ω

    NG: REPAIR OR REPLACE WIRE HARNESS 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE