LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. CHECK MODE IN WHICH IMAGE HAS LINES 
    1. Check the mode in which the image has lines.

      Result 

      RESULT CHART

      Result Proceed to
      During VTR, DVD and DVD-P (rear seat only) image A
      During DVD and DVD-P (rear seat only) image B
      Only during VTR image C

    B: Go to step   3 

    C: Go to step   5 

    A: GO TO NEXT STEP 

  2. CHECK DISPLAY SIGNAL CIRCUIT 
    1. Inspect the display signal circuits below.
      1. Inspect the display signal circuit between the radio receiver and television display assembly (see DISPLAY SIGNAL CIRCUIT BETWEEN RADIO RECEIVER AND TELEVISION DISPLAY ASSEMBLY  ).
      2. Inspect the display signal circuit between the video terminal and television display (see DISPLAY SIGNAL CIRCUIT BETWEEN VIDEO TERMINAL AND TELEVISION DISPLAY  ).
    2. If display signal circuit is operating normally, proceed to next step.

    NEXT: REPLACE TELEVISION DISPLAY ASSEMBLY (See  TELEVISION DISPLAY (FOR LONG BODY)   ) 

  3. CHECK NTSC/PAL SIGNAL (RSE IMAGE QUALITY ADJUSTMENT SCREEN) 
    1. During the VTR image, check if the changing of the NTSC/PAL signal is normal by pressing the remote controller's DISPLAY switch, entering the RSE image adjustment screen, and pressing the PAL VIDEO button.

      OK: Returned to normal after pressing image quality adjustment screen's PAL VIDEO button. 

      Fig 1: Identifying Pal Video Button
      G04953885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: Go to step 4 

    OK: NORMAL 

  4. REPLACE EXTERNAL DEVICE WITH NORMAL ONE AND CHECK 
    1. Replace the external device with a normal one and check if the same problem occurs again.

      OK: Same problem does not occur. 

    NG: GO TO DISPLAY SIGNAL CIRCUIT BETWEEN VIDEO TERMINAL AND TELEVISION DISPLAY (See  DISPLAY SIGNAL CIRCUIT BETWEEN VIDEO TERMINAL AND TELEVISION DISPLAY   ) 

    OK: END (EXTERNAL DEVICE IS DEFECTIVE) 

  5. CHECK DISC 
    1. Check that the disc is not deformed or cracked.

      OK: No deformation or cracks on the disc. 

      Fig 2: Identifying Disc In Deformed Or Cracked Condition
      G04948904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: CHANGE DISC 

    OK: GO TO NEXT STEP 

  6. DISC CLEANING 
    1. Disc cleaning
      1. If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
        NOTE: Do not use a conventional record cleaner or antistatic preservative.
        Fig 3: Cleaning Disc With Soft Cloth
        G04833494Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NEXT: GO TO DISPLAY SIGNAL CIRCUIT BETWEEN RADIO RECEIVER AND TELEVISION DISPLAY ASSEMBLY (See  DISPLAY SIGNAL CIRCUIT BETWEEN RADIO RECEIVER AND TELEVISION DISPLAY ASSEMBLY   )