Inspection Procedure
- CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - DISC PLAYER)
- Disconnect the R30 controller connector.
- Disconnect the R16 player connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Condition Specified Condition R30-16(HP2R)-R16-15 (HP2R) Always Below 1 Ω R30-17(HP2L)-R16-16 (HP2L) Always Below 1 Ω R30-18(SG2)-R16-17 (SGN2) Always Below 1 Ω R30-13(HP1R)-R16-1 (HP1R) Always Below 1 Ω R30-14(HP1L)-R16-2 (HP1L) Always Below 1 Ω R30-15(SG1)-R16-3 (SGN1) Always Below 1 Ω R16-15(HP2R)-Body ground Always 10 kΩ or higher R16-16(HP2L)-Body ground Always 10 kΩ or higher R16-1 (HP1R)-Body ground Always 10 kΩ or higher R16-2(HP1L)-Body ground Always 10 kΩ or higher
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )