LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. CHECK MULTI-DISPLAY CONTROLLER 
    1. Measure the voltage according to the value(s) in the table below.
      Fig 1: Identifying Multi-Display Controller Connector Terminal
      G04953942Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R32-19 (MUT4) - Body ground Turn engine switch on (ACC), audio system is playing → Changing modes Above 3.5 V → Below 1 V

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  2. CHECK SATELLITE RADIO TUNER AND/OR DISC PLAYER 
    1. Check if the satellite radio tuner and/or disc player are equipped on the vehicle.

      Result 

      RESULT CHART

      Result Proceed to
      w/o Satellite Radio Tuner, w/o Disc Player A
      w/ Satellite Radio Tuner, w/o Disc Player B
      w/o Satellite Radio Tuner, w/ Disc Player C
      w/ Satellite Radio Tuner, w/ Disc Player D

    B: Go to step   4 

    C: Go to step   7 

    D: Go to step   10 

    A: GO TO NEXT STEP 

  3. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - MULTI-DISPLAY CONTROLLER) 
    1. Disconnect the L52 receiver connector.
    2. Disconnect the R32 controller connector.
      Fig 2: Identifying Radio Receiver And Multi-Display Controller Connector Terminal
      G04953943Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      L52-19(RMUT)-R32-19 (MUT4) Always Below 1 Ω
      R32-19(MUT4)-Body ground Always 10 kΩ or higher

      Result 

      RESULT CHART

      Result Proceed to
      NG A
      OK B

    B: Go to step   15 

    A: REPAIR OR REPLACE HARNESS OR CONNECTOR 

  4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SATELLITE RADIO TUNER) 
    1. Disconnect the L52 receiver connector.
    2. Disconnect the R29 tuner connector.
      Fig 3: Identifying Radio Receiver And Satellite Radio Tuner Connector Terminal
      G04953944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      L52-19 (RMUT) - R29-14 (MUT3) Always Below 1 Ω
      L52-19 (RMUT) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  5. CHECK HARNESS AND CONNECTOR (SATELLITE RADIO TUNER - MULTI-DISPLAY CONTROLLER) 
    1. Disconnect the R29 tuner connector.
    2. Disconnect the R32 controller connector.
      Fig 4: Identifying Satellite Radio Tuner And Multi-Display Controller Connector Terminal
      G04953945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R29-13(MUT4)-R32-19 (MUT4) Always Below 1 Ω
      R32-19 (MUT4) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  6. REPLACE SATELLITE RADIO TUNER WITH NORMAL ONE AND CHECK 
    1. Replace the satellite radio tuner with a normal one and check if the same problem occurs again (see REMOVAL  ).

      OK: Same problem does not occur. 

    NG: Go to step   15 

    OK: END (SATELLITE RADIO TUNER IS DEFECTIVE) 

  7. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - DISC PLAYER) 
    1. Disconnect the L52 receiver connector.
    2. Disconnect the R16 player connector.
      Fig 5: Identifying Radio Receiver And Disc Player Connector Terminal
      G04953946Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      L52-19 (RMUT) - R16-8 (MUT2) Always Below 1 Ω
      L52-19 (RMUT)-Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  8. CHECK HARNESS AND CONNECTOR (DISC PLAYER - MULTI-DISPLAY CONTROLLER) 
    1. Disconnect the R16 player connector.
    2. Disconnect the R32 controller connector.
      Fig 6: Identifying Disc Player And Multi-Display Controller Connector Terminal
      G04953947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R16-14 (MUTE) - R32-19 (MUT4) Always Below 1 Ω
      R32-19 (MUT4) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  9. REPLACE DISC PLAYER WITH NORMAL ONE AND CHECK 
    1. Replace the disc player with a normal one and check if the same problem occurs again (see DISC PLAYER (FOR OTTOMAN)  ).

      OK: Same problem does not occur. 

    NG: Go to step   15 

    OK: END (DISC PLAYER IS DEFECTIVE) 

  10. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - SATELLITE RADIO TUNER) 
    1. Disconnect the L52 receiver connector.
    2. Disconnect the R29 tuner connector.
      Fig 7: Identifying Radio Receiver And Satellite Radio Tuner Connector Terminal
      G04953944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      L52-19(RMUT)-R29-14 (MUT3) Always Below 1 Ω
      L52-19 (RMUT) -Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  11. CHECK HARNESS AND CONNECTOR (SATELLITE RADIO TUNER - DISC PLAYER) 
    1. Disconnect the R29 tuner connector.
    2. Disconnect the R16 player connector.
      Fig 8: Identifying Satellite Radio Tuner And Disc Player Connector Terminal
      G04953949Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R29-13 (MUT4) - R16-8 (MUT2) Always Below 1 Ω
      R29-13(MUT4)-Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  12. CHECK HARNESS AND CONNECTOR (DISC PLAYER - MULTI-DISPLAY CONTROLLER) 
    1. Disconnect the R16 player connector.
    2. Disconnect the R32 controller connector.
      Fig 9: Identifying Disc Player And Multi-Display Controller Connector Terminal
      G04953947Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R16-14(MUTE)-R32-19 (MUT4) Always Below 1 Ω
      R32-19 (MUT4) - Body ground Always 10 kΩ or higher

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  13. REPLACE SATELLITE RADIO TUNER WITH NORMAL ONE AND CHECK 
    1. Replace the satellite radio tuner with a normal one and check if the same problem occurs again (see REMOVAL  ).

      OK: Same problem does not occur. 

    NG: Go to step 14 

    OK: END (SATELLITE RADIO TUNER IS DEFECTIVE) 

  14. REPLACE DISC PLAYER WITH NORMAL ONE AND CHECK 
    1. Replace the disc player with a normal one and check if the same problem occurs again (see DISC PLAYER (FOR OTTOMAN)  ).

      OK: Same problem does not occur. 

    NG: Go to step 15 

    OK: END (DISC PLAYER IS DEFECTIVE) 

  15. CHECK MULTI-DISPLAY CONTROLLER 
    1. Reconnect the R32 controller connector.
      Fig 10: Identifying Multi-Display Controller Connector Terminal
      G04953942Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Switch Condition Specified Condition
      R32-19 (MUT4) - Body ground Audio system is playing Above 3.5 V

    NG: REPLACE MULTI-DISPLAY CONTROLLER (See  REMOVAL   ) 

    OK: REPLACE RADIO RECEIVER (See  REMOVAL   )