LEMON Manuals: Even more car manuals for everyone

Amplifier Antenna: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE REAR SEAT ASSEMBLY 
    1. Remove the rear seat assembly for power seat (see REMOVAL ).
    2. Remove the rear seat assembly for ottoman (see REMOVAL ).
    3. Remove the rear seat assembly for fixed seat (see REMOVAL ).
  4. REMOVE REAR DOOR SCUFF PLATE LH 
    1. Remove the rear door scuff plate LH for standard body (see REMOVAL ).
    2. Remove the rear door scuff plate LH for long body (see REMOVAL ).
  5. REMOVE REAR DOOR SCUFF PLATE RH 
    1. Remove the rear door scuff plate RH for standard body (see REMOVAL ).
    2. Remove the rear door scuff plate RH for long body (see REMOVAL ).
  6. REMOVE REAR SEAT SIDE GARNISH LH  (See REMOVAL )
  7. REMOVE REAR SEAT SIDE GARNISH RH  (See REMOVAL )
  8. REMOVE ROOF SIDE GARNISH INNER LH  (See REMOVAL )
  9. REMOVE ROOF SIDE GARNISH INNER RH  (See REMOVAL )
  10. REMOVE SPOT LIGHT LENS (for Long Body)  (See REMOVAL )
  11. REMOVE ROOF CONSOLE BOX ASSEMBLY (for Long Body)  (See REMOVAL )
  12. REMOVE SPOT LIGHT ASSEMBLY  (See PROBLEM SYMPTOMS TABLE 3)
  13. REMOVE REAR VANITY LIGHT ASSEMBLY  (See REMOVAL )
  14. REMOVE COAT HOOK  (See REMOVAL )
  15. REMOVE ROOF SIDE REGISTER BEZEL LH (w/ Rear Cooler)  (See REMOVAL )
  16. REMOVE ROOF SIDE REGISTER BEZEL RH (w/ Rear Cooler)  (See REMOVAL )
  17. REMOVE ASSIST GRIP SUB-ASSEMBLY  (See REMOVAL )
  18. REMOVE AMPLIFIER ANTENNA ASSEMBLY 
    1. Partially remove the roof headlining.

      HINT:

      It is not necessary to completely remove the roof headlining. Slightly lower the rear section of the roof headlining so that the amplifier antenna can be removed.

      For standard body, refer to the following procedures (see REMOVAL ).

      For long body, refer to the following procedures (see REMOVAL ).

    2. Disconnect the antenna connectors.
    3. Detach the 4 clips labeled A and remove the 2 nuts labeled B.
    4. Detach the clip labeled C and remove the amplifier antenna.
      NOTE: Do not reuse the removed clip.
      Fig 1: Identifying Amplifier Antenna Assembly Clips And Nuts
      G04954107Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002