LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. INSPECT FUSE (ACC) 
    1. Disconnect the ACC fuse from the luggage room junction block.
    2. Measure the resistance of the fuse.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      ACC fuse Always Below 1 Ω

    NG: REPLACE FUSE 

    OK: GO TO NEXT STEP 

  2. CHECK HARNESS AND CONNECTOR (AMPLIFIER - BATTERY AND BODY GROUND) 
    1. Disconnect the R34 and R38 amplifier connectors.
      Fig 1: Identifying Amplifier And Battery And Body Ground Connector Terminal
      G04953753Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      R38-2 (GND) - Body ground Always Below 1 Ω
      R38-6 (GND2) - Body ground Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard voltage 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Switch Condition Specified Condition
      R38-1 (+B) - Body ground Always 11 to 14 V
      R38-3 (+B2) - Body ground Always 11 to 14 V
      R34-12 (ACC) -Body ground Engine switch on (ACC) 11 to 14 V

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   )