Inspection Procedure
- INSPECT RADIO RECEIVER ASSEMBLY
- Disconnect the L53, L51, L57 and L52 receiver connectors.
- Measure the resistance according to the value(s) in the table below.
Standard resistance:
for CD changer models
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Condition Specified Condition L53-9 (TXM+) - L53-10 (TXM-) Always 60 to 80 Ω L51-5 (ATX+) - L51-15 (ATX-) Always 60 to 80 Ω L57-9 (TX+) - L57-10 (TX-) Always 60 to 80 Ω for DVD changer models
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Condition Specified Condition L53-9 (TXM+) - L53-10 (TXM-) Always 60 to 80 Ω L51-5 (ATX+) - L51-15 (ATX-) Always 60 to 80 Ω L52-9 (TX+) - L52-10 (TX-) Always 60 to 80 Ω
NG: REPLACE RADIO RECEIVER ASSEMBLY (See REMOVAL )
OK: GO TO NEXT STEP
- CHECK HARNESS AND CONNECTOR
HINT:
For details of the connectors, refer to "TERMINALS OF ECU " .
- Referring to the AVC-LAN wiring diagram, check all AVC-LAN circuits.
- Disconnect all connectors in all AVC-LAN circuits.
- Check for an open or short in all AVC-LAN circuits.
OK :
There is no open or short circuit.
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )
- Referring to the AVC-LAN wiring diagram, check all AVC-LAN circuits.