LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. INSPECT SATELLITE SWITCH 
    1. Disconnect the connector from the satellite switch.
    2. Measure the resistance according to the value (s) in the table below.
      Fig 1: Identifying Satellite Switch
      G05320820Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      SATELLITE SWITCH

      Tester Connection Condition Specified Condition
      J16-2 (LSET) - J16-5 (E) Satellite switch LH is pressed Below 1 Ω
      J16-2 (LSET) - J16-5 (E) Satellite switch LH is not pressed 10 kΩ or higher
      J16-3 (SET) - J16-5 (E) Satellite switch ON/OFF is pressed Below 1 Ω
      J16-3 (SET) - J16-5 (E) Satellite switch ON/ OFF is not pressed 10 kΩ or higher
      J16-4 (RSET) - J16-5 (E) Satellite switch RH is pressed Below 1 Ω
      J16-4 (RSET) - J16-5 (E) Satellite switch RH is not pressed Below 1 Ω

    NG: REPLACE SATELLITE SWITCH 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (COMBINATION METER - SATELLITE SWITCH) 
    1. Disconnect the J35 and J16 connectors.
    2. Measure the resistance according to the value (s) in the table below.

      Standard resistance 

      COMBINATION METER - SATELLITE SWITCH

      Tester Connection Condition Specified Condition
      J35-5 (RSEL) - J16-4 (RSET) Always Below 1 Ω
      J35-6 (LSEL) - J16-2 (LSET) Always Below 1 Ω
      J35-7 (SEL) - J16-3 (SET) Always Below 1 Ω
      J16-2 (LSET) - Body ground Always 10 kΩ or higher
      J16-3 (SET) - Body ground Always 10 kΩ or higher
      J16-4 (RSET) - Body ground Always 10 kΩ or higher
      Fig 2: Identifying Harness And Connector (Combination Meter - Satellite Switch)
      G05320821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: REPLACE COMBINATION METER ASSEMBLY