LEMON Manuals: Even more car manuals for everyone

Lower Ball Joint: Installation

  1. Install lower ball joint to steering knuckle with bolts. Tighten to specification. See TORQUE SPECIFICATIONS .
  2. Install lower ball joint to No. 1 lower control arm with nut. Tighten to specification. See TORQUE SPECIFICATIONS . Install NEW cotter pin. If holes for cotter pin are not aligned, tighten nut further up to 60 degrees.
  3. Install tie rod end to lower ball joint with nut. Tighten to specification. See TORQUE SPECIFICATIONS . Install NEW clip. If holes for clip are not aligned, tighten nut further up to 60 degrees.
  4. Install disc, brake caliper and bolts. Tighten to specification. See TORQUE SPECIFICATIONS .
  5. Install front wheel. Tighten lug nuts to specification. See TORQUE SPECIFICATIONS .
  6. Check ABS speed sensor signal. For vehicles with VSC, see TEST A: ABS SENSOR SIGNAL CHECK under SYSTEM TESTS in ANTI-LOCK/VEHICLE SKID CONTROL - IS 300 article in BRAKES. For vehicles without VSC, see SPEED SENSOR SIGNAL CHECK under COMPONENT TESTS in ANTI-LOCK - IS 300 article in BRAKES.