LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. INSPECT SEAT MEMORY SWITCH 
    1. Disconnect the seat memory switch connector.
    2. Check the continuity of each terminal when each switch is operated.

      Standard: 

      SWITCH TERMINALS CONTINUITY CONDITIONS

      Terminal No. Switch Position Specified Condition
      1 <--> 2 SET switch ON Continuity
      2 <--> 3 SW1 switch ON Continuity
      2 <--> 4 SW2 switch ON Continuity
      Fig 1: Checking Continuity Of Each Terminal
      G03470635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPLACE SEAT MEMORY SWITCH 
    2. OK: GO TO NEXT STEP 
  2. CHECK WIRE HARNESS (SEAT MEMORY SWITCH <--> INSTRUMENT PANEL JUNCTION BLOCK ASSY (BODY ECU)) 
    1. Disconnect the D22 switch and B3 ECU connectors.
    2. Check the continuity between the wire harness side connectors.
      Fig 2: Checking Continuity Between Wire Harness Side Connectors
      G03470636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard: 

      TERMINALS CONTINUITY CONDITIONS

      Symbols (Terminal No.) Condition Specified Condition
      M1 (D22-3) <--> M1 (B3-20) Constant Continuity
      M2 (D22-4) <--> M2 (B3-2) Constant Continuity
      MRY (D22-2) <--> MM (B3-8) Constant Continuity
      E (D22-1) <--> Body ground Constant Continuity
    1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 
    2. OK: CHECK AND REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSY (BODY ECU) (See  INSTRUMENT PANEL JUNCTION & RELAY BLOCKS  )