LEMON Manuals: Even more car manuals for everyone

EAS Indicator Lamps Flicker (86/05/99/NAS)

Publication date: 1999-05-07
Reference number: 86/05/99/NAS

EAS INDICATOR LAMPS FLICKER

EAS INDICATOR LAMPS FLICKER

TECHNICAL SERVICE BULLETIN

Reference Number(s): 86/05/99/NAS, Date of Issue:  May 07, 1999
LAND ROVER: Range Rover (LP)
ISSUE: 1
SECTION: Electrical
AFFECTED VEHICLES: Range Rover (LP) XA410504 and up

SITUATION:

ELECTRONIC AIR SUSPENSION INDICATOR LIGHTS FLICKER 

On Range Rovers in the above VIN range, the EAS indicator lamps may momentarily flash while the transmission selector is moved into the "P" position. The symptom can be intermittent, and the specific lamps that flash are random in nature. A voltage spike that is generated by the key interlock solenoid when it is de-energized causes this symptom.

RESOLUTION:

INSTALL SUPPRESSION LINK 

A suppression link containing a zener diode has been developed to address this symptom. Upon customer complaints matching the above description, verify the symptom and install a suppression link as described below.

PARTS INFORMATION:

PARTS INFORMATION CHART

P/N Description
LRN-00-0008 Key Interlock Suppression Link

WARRANTY CLAIMS:

57.40.89/28 Time 0.60 hrs.
Install diode

FAULT CODE: N 

Normal warranty policy and procedures apply 

REPAIR PROCEDURE:

DISASSEMBLY

  1. Disconnect battery negative terminal.
  2. Remove driver's side closure panel (six screws).
  3. Remove lower half of steering column shroud (six screws).

INSTALLATION OF DIODE

  1. Locate Interlock Solenoid connector "C069" on right hand side of steering column.
  2. Connect suppression link to the PY (purple/yellow) wire using supplied IDC connector as follows:
    • Position PY wire on one side of the connector base.
    • Position bare end of suppression link on the remaining side of the connector base.
    • Snap the clear cover onto the base and seat it fully using pliers.
  3. Route suppression link as shown in Fig 1 .
  4. Secure suppression link ring terminal under bottom connector support bracket screw as shown in Fig 1 .
Fig 1: Proper Routing Of Suppression Link
G03379297

ASSEMBLY

  1. Install lower half of steering column shroud (six screws).
  2. Install driver's side closure panel (six screws).
  3. Connect battery negative terminal.

TEST INTERLOCK OPERATION

  1. Set the parking brake.
  2. Place the transmission in "N" (Neutral) position.
  3. Verify that the key CANNOT BE  removed.
  4. Place the transmission in position "P" (Park).
  5. Verify that the key CAN BE  removed.