Removal And Installation: Removal
- Turn the IG OFF, separate the auxiliary battery (12 V) (-) terminal, and disconnect the high voltage service interlock connector.
- Separate the auxiliary battery (12 V) (-) terminal (A) after removing the nut.
Tightening torque:
7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb.ft)
- Remove the PE room junction box cover (A).
- Disconnect the high voltage service interlock connector (A).WARNING:
- Wait more than 5 minutes for capacitor of the high voltage battery system to be discharged completely.
- Do not install the PE room junction box cover as the high voltage service interlock connector may be connected.
NOTE: The high voltage service interlock connector cannot be completely removed.
- Separate the auxiliary battery (12 V) (-) terminal (A) after removing the nut.
- Remove the front wheel and tires.
(Refer to Suspension System - " WHEEL ")
- Separate the front dust cover (A) using the fasteners and screws.
- Disconnect the front wheel speed sensor connector (A).
- Separate the front wheel speed sensor wire (B) after removing the clip (A) and bolt.
Tightening torque:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)
- Separate the front wheel speed sensor wire (A) from the brake hose bracket.
- Remove the front wheel speed sensor (A) after removing the bolt.
Tightening torque:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)