Removal And Installation: Removal
WARNING:
- When working on the high voltage system, the work should be performed by technicians who have completed the relevant training. A lack of understanding of the high voltage system can lead to serious accidents due to electric shock or short circuit.
- When working on the high voltage system or related components, be sure to observe and be aware of the "Safety Precautions, Cautions and Warnings". If not, it may cause serious accidents due to electric shock or short circuit. Refer to HIGH VOLTAGE SYSTEM GENERAL SAFETY INFORMATION AND CAUTION
- Remove the front pillar trim.
(Refer to Interior Trim - " FRONT PILLAR TRIM ")
- Remove the inside rear view mirror assembly.
(Refer to Mirror - " INSIDE REAR VIEW MIRROR ")
- Remove the auto defogging sensor.
(Refer to Heater and Air Conditioning Unit - " AUTO DEFOGGING SENSOR ")
- Remove the rain sensor.
(Refer to Body Electrical System - " RAIN SENSOR ")
- Remove the front view camera unit.
(Refer to Advanced Driver Assistance Systems (ADAS) - "FRONT CAMERA ")
- Remove the cowl top cover.
(Refer to Cowl Top Cover - " COWL TOP COVER ")
- Remove the windshield glass side garnishes (A).
- Carefully cut out the windshield glass molding (A) using a cutter knife (B).
Information
When using a cutter knife, use the blade of a knife with a 20 to 30 cm-long.
- Insert the piano wire (A) in the corner side.
- While pulling the piano wire (A) in the direction of the arrow, cut out the sealant on the front edge side (B).CAUTION:
- Be careful not to burn hands as the excessive heat may be generated while using the wire.
- Be careful as the wire may break when working.
- Cut the sealant in sections (A-A) and (B-B) while pulling the piano wire left and right.
- Cut off the sealant between (A-A) area by using a cutter knife.NOTE: Cut the sealant carefully as it may damage the crash pad when working the area (A-A). Be careful not to damage the body painting surface.
Information
When using a cutter knife, use the blade of a knife with a 20 to 30 cm-long.
- Carefully remove the windshield glass (A) using the glass holder (B).