LEMON Manuals: Even more car manuals for everyone

Removal And Installation

  1. Disconnect the battery negative terminal.
  2. Remove the engine cover.

    (Refer to Engine and Transaxle Assembly - "ENGINE COVER ")

  3. Remove the engine room under cover.

    (Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")

  4. Drain the engine coolant.

    (Refer to Cooling System - "COOLANT ")

  5. Remove the exhaust manifold.

    (Refer to Intake and Exhaust System - "EXHAUST MANIFOLD ")

  6. Disconnect the EGR cooler inlet & outlet hose (A).
    G13704325Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the EGR cooler pipe B (A).

    Tightening torque: 

    18.6-23.5 N.m (1.9-2.4 kgf.m, 13.7-17.4 lb.ft)

    G13704326Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the EGR cooler (A).

    Tightening torque: 

    18.6-23.5 N.m (1.9-2.4 kgf.m, 13.7-17.4 lb.ft)

    G13704327Courtesy of KIA MOTORS AMERICA, INC.
  9. Install in the reverse order of removal.
    NOTE:
    • When installing, replace with a new gasket.
    • When installing the EGR cooler, tighten the bolts with pre-torque first, and then tighten the bolts with specified torque in the sequence shown.
      Fig 1: EGR Cooler Bolts Tightening Sequence
      G13704328Courtesy of KIA MOTORS AMERICA, INC.
  10. Fill with engine coolant.

    (Refer to Cooling System - "COOLANT ")

    NOTE: The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.