LEMON Manuals: Even more car manuals for everyone

Removal And Installation

WARNING: This page is about a different car, the 2024 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  2. Disconnect the crankshaft position sensor connector (A).
    G14560839Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the engine room under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  4. Remove the sensor (A) by loosening the mounting bolt.

    Crankshaft position sensor mounting bolt: 

    7.8 - 11.8 Nm (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    G14560840Courtesy of KIA MOTORS AMERICA, INC.
  5. Install in the reverse order of removal.
NOTE:
  • Install the Crankshaft Position Sensor (CKPS) to the specified torque.
  • If the CKPS is dropped, it may internal damage. (Do not reuse)
  • Install the CKPS by pushing it into the mounting hole when installing it. At this time do not impact the sensor.
  • Apply the engine oil to the O-ring.