Repair Procedures: Inspection
WARNING: This page is about a different car, the 2019 Kia Stinger. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch OFF.
- Disconnect the mode control actuator connector.
- Verify that the mode control actuator operates to the defrost mode when 12V is connected to terminal 3 and ground to terminal 7.
Verify that the mode control actuator operates to the vent mode when connected in reverse.
- Connect the mode control actuator connector.
- Turn the ignition switch ON.
- Check the voltage between terminals 5 and 6.
Specification
Door position Voltage (V) Error detecting Vent 0.3 ±0.15 Low voltage: 0.1V or less
High voltage: 4.9V or lessDefrost 4.7 ±0.15 The current position of the actuator will be sent to the control unit.
- If the measured voltage is not within the specification, substitute with a verified temperature control actuator and check for proper operation.
- Replace the mode control actuator if it is proved that there is a problem with it.