Ground Circuit Inspection
- Ignition "OFF"
- Disconnect the Oil Pressure Switch connector.
- Ignition "ON".
- Measure voltage between Pin No. 3 (Sensor Power) terminal of Oil Pressure Switch harness connector and chassis ground. (A)
- Measure voltage between Pin No. 3 (Sensor Power) Terminal And Pin No. 2 (Sensor Ground) terminal of the Oil Pressure Switch. (B)
Specification: "A" - "B" = below 200mV
- Is the measured value within specification?
YES
- Go to "SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair as necessary and go to "Verification Of REPAIR " procedure.