[Low Pressure Fuel Line]
- Turn the ignition switch OFF, and then remove battery (-) cable.
- Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
- Remove the fuel tank.
(Refer to "FUEL TANK ")
- Open the low pressure fuel tube clip (A).
- Release the low pressure fuel quick-connector (A) using the clip remover (B).
NOTE: When removing the low pressure fuel quick-connector, use a clip remover as shown in the image below.
- Disconnect the vapor hose (A) and low pressure fuel quick-connector (B).
- Lift the vehicle.
- Remove the under cover LH (A).
- Remove the under cover RH (A).
- Remove the front muffler mounting nuts (A)
- Remove the center muffler and rear muffler.
- Remove the rear heat protector (A).
- Remove the front heat protector (A).
- Remove the low pressure fuel tube clamp mounting nut (A).
Fuel tube clamp mounting nut:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
- Unclip the fuel feed tube (A) and vapor tube (B) holders using a flat-head screwdriver.
- Open the holder (A)
- Remove the fuel line (A) from the vehicle,