Monitor GDS Data
- Connect GDS to Data Link Connector (DLC).
- IG "ON".
- Select "Diagnostic Trouble Codes (DTC)" button, then press "DTC Status" to check DTC's information from the DTCs menu.
- Read "DTC Status" parameter.
- Record all DTCs, DTC status, and freeze frame data. Does DTC Status indicate "Present"?
YES
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.
NO
- Clear DTC and check if this DTC is set after test driving under enable conditions. If DTC isn't displayed after the test, it was intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.