LEMON Manuals: Even more car manuals for everyone

Disassembly & Reassembly

  1. Remove the rear cover (A).
    Fig 1: Removing The Rear Cover
    G00718850Courtesy of KIA MOTORS AMERICA, INC.
  2. Unsolder the 4 stator leads (A) to the main diodes on the rectifier (B).
    CAUTION:
    • When soldering or unsoldering, be careful not to heat the diodes for too long.
    • Be careful that excessive force is not exerted on the leads of the diodes.
    Fig 2: Unsoldering 4 Stator Leads
    G00718851Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the rectifier assembly (A).
    Fig 3: Removing Rectifier Assembly
    G00718852Courtesy of KIA MOTORS AMERICA, INC.
  4. Unsolder between rectifier (A) and brush holder (B).
    Fig 4: Unsoldering Between Rectifier & Brush Holder
    G00718853Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the rear bracket (A).
    Fig 5: Removing Rear Bracket
    G00718854Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the nut (A), pulley (B) and spacer (C).
    Fig 6: Removing Nut, Pulley & Spacer
    G00718855Courtesy of KIA MOTORS AMERICA, INC.
  7. Disconnect the stator (A), rotor (B) and front bracket (C).
    Fig 7: Disconnecting Stator, Rotor & Front Bracket
    G00718856Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the rear bearing (A) and cover (B).
    Fig 8: Removing Rear Bearing & Cover
    G00718857Courtesy of KIA MOTORS AMERICA, INC.
  9. Reassembly is the reverse order of disassembly.
    NOTE: Before the rotor is attached to the rear bracket, insert a wire through the small hole in the rear bracket to lock the brush. After the rotor has been installed, the wire can be removed.