LEMON Manuals: Even more car manuals for everyone

Monitor Scan Tool Data

  1. Connect scan tool to DLC (Data Link Connector)
  2. IG "ON" & Monitor that any different DTC (Diagnostic Trouble Code) is existed. (There will be at least one more DTC which causes this DTC P1295 to retrieve)
  3. Repair the DTCs cause DTC P1295 first according to the designated trouble shooting guide. (After repairing the DTCs cause DTC P1295, don't forget to do "ETC Initialization" as follows.)
  4. Is the same DTC occurred?

    YES 

    • Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scan tool that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others

    NO 

    * Procedure of ETS Initialization

    1. Erase the trouble codes on ECM
    2. Turn the ignition key off and keep this condition until the main relay is turned off (It will take 10sec.)
    3. Turn ignition key on more than 1second to record the throttle motor position on the EEPROM