LEMON Manuals: Even more car manuals for everyone

Charging System Test Procedure

  1. Press ENTER to begin charging system test.
    Fig 1: Micro 570 Analyzer - Press ENTER To Begin Charging System Test
    G06415733Courtesy of KIA MOTORS AMERICA, INC.
  2. ENTER button is pressed, the tester displays the actual voltage of alternator.

    Press ENTER to test the charging system.

    Fig 2: Micro 570 Analyzer - Press ENTER To Test Charging System
    G06415734Courtesy of KIA MOTORS AMERICA, INC.
  3. Turn off all electrical load and rev engine for 5 seconds by pressing the accelerator pedal.
    Fig 3: Micro 570 Analyzer - Load Off REV Engine 5Sec
    G06415735Courtesy of KIA MOTORS AMERICA, INC.
  4. Press ENTER.
    Fig 4: Micro 570 Analyzer - Press ENTER
    G06415736Courtesy of KIA MOTORS AMERICA, INC.
  5. The MICRO 570 analyzer charging system output at idle for comparison to other readings.
    Fig 5: Micro 570 Analyzer - MICRO 570 Analyzer Charging System Output
    G06415737Courtesy of KIA MOTORS AMERICA, INC.
  6. Take a relevant action according to the test results by referring to the table below after shutting off the engine and disconnect the tester clamps from the battery.
    Fig 6: Micro 570 Analyzer - Diode Ripple Normal
    G06415738Courtesy of KIA MOTORS AMERICA, INC.

Charging System Test Results 

CHARGING SYSTEM TEST RESULTS REFERENCE

Result On Printer Remedy
Charging system normal/Diode ripple normal Charging system is normal
No charging voltage Alternator does not supply charging current to battery
  • Check belts, connection between alternator and battery

Replace belts or cable or alternator as necessary
Low charging voltage Alternator does not supply charging current to battery and electrical load to system fully
  • Check belts and alternator and replace as necessary
High charging voltage The voltage from alternator to battery is higher than normal limit during voltage regulating.
  • Check connection and ground and replace regulator as necessary
  • Check electrolyte level in the battery
Excess ripple detected One or more diodes in the alternator is not functioning properly
  • Check alternator mounting and belts and replace as necessary