LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check Open in signal circuit.
    1. Key "OFF".
    2. Disconnect CMPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 2 of CMPS harness connector and chassis ground.

      Specification: Approx 12V

    5. Is the measured voltage within specification?

      YES 

      • Go to  2 "Short to power circuit inspection" procedure.

      NO 

  2. Check Short to power in signal circuit.
    1. Key "OFF".
    2. Disconnect CMPS connector and ECM/PCM connector.
    3. Measure the resistance between terminal 1 and 2 of CMPS harness connector.

      Specification: Infinite

    4. Is the measured resistance within specifications?

      YES 

      NO