LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check Open in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 1 of CKPS harness connector and chassis ground. Then, measure the voltage between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Approx 2.5V

    5. Is the measured voltage within specification?

      YES 

      • Go to  2 "Check Short in signal circuit" procedure.

      NO 

  2. Check Short in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector and ECM/PCM connector.
    3. Measure the resistance between terminals 1 and 2 of CKPS harness connector.

      Specification: Infinite

    4. Is the measured resistance within specifications?

      YES 

      NO