LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check Open in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 1 of CKPS harness connector and chassis ground. Then, measure the voltage between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Approx 2.5V

    5. Is the measured voltage within specification?

      YES 

      NO 

      • Go to  2 "Check Short to ground in signal circuit" procedure.
  2. Check Short to ground in signal circuit.
    1. Key "OFF".
    2. Disconnect CKPS connector and ECM/PCM connector.
    3. Measure the resistance between terminal 1 of CKPS harness connector and chassis ground. Then, measure the resistance between terminal 2 of CKPS harness connector and chassis ground.

      Specification: Infinite

    4. Is the measured resistance within specifications?

      YES 

      NO