LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check for open in signal circuit.
    1. Key "OFF".
    2. Disconnect TPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 1 of TPS harness connector and chassis ground.

      Specification: Approx. 5V

    5. Is the measured voltage within specification?

      YES 

      • Go to  2 "Check for Short in signal circuit" procedure.

      NO 

  2. Check for short in signal circuit.
    1. Key "OFF".
    2. Disconnect TPS connector and ECM/PCM connector.
    3. Measure the resistance between terminal 1 and 2 of TPS harness connector.

      Specification: Infinite

    4. Is the measured resistance within specification ?

      YES 

      NO